User Tools
surfski_rebuild_3_30_2020
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
surfski_rebuild_3_30_2020 [2020/09/15 20:38] preavley |
surfski_rebuild_3_30_2020 [2025/03/23 19:50] (current) |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| KO | KO | ||
| - | {{ :equipment:rebuild_1.jpg?direct&533x400 }} | + | {{ :equipment:rebuild_1.jpg?direct&533x400 |rebuild_1.jpg}} |
| - | {{ :equipment:rebuild_2.jpg?direct&533x711 }} | + | {{ :equipment:rebuild_2.jpg?direct&533x711 |rebuild_2.jpg}} |
| **Waterman Larry** \\ | **Waterman Larry** \\ | ||
| Line 37: | Line 37: | ||
| Larry Goodson | Larry Goodson | ||
| - | {{ :equipment:rebuild_3.jpg?direct&533x400 }} | + | {{ :equipment:rebuild_3.jpg?direct&533x400 |rebuild_3.jpg}} |
| **David Scherrer** \\ | **David Scherrer** \\ | ||
| Line 46: | Line 46: | ||
| –But I am ahead of myself…Question is, how much time do yo have?\\ | –But I am ahead of myself…Question is, how much time do yo have?\\ | ||
| Clean out the existing spline and make all your major repairs inside hull using epoxy and glass cloth.\\ | Clean out the existing spline and make all your major repairs inside hull using epoxy and glass cloth.\\ | ||
| - | After the repairs are done attach guide tabs using gulled on tabs every 9 inches or so as a guide. I used pieces of plastic about 2 inches by 1 inch.\\ | + | After the repairs are done attach guide tabs using glued on tabs every 9 inches or so as a guide. I used pieces of plastic about 2 inches by 1 inch.\\ |
| Then replace your foam spline. Do not use wood. It will eventually get wet and get very heavy and fall apart. Valhalla skis had that big problem years ago.\\ | Then replace your foam spline. Do not use wood. It will eventually get wet and get very heavy and fall apart. Valhalla skis had that big problem years ago.\\ | ||
| Liberally coat the top of the spline with adhesive foam ( from H.S.) and fit on deck. Temporary tape on deck and let foam dry and settle.\\ | Liberally coat the top of the spline with adhesive foam ( from H.S.) and fit on deck. Temporary tape on deck and let foam dry and settle.\\ | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
