User Tools
huki_ruddershaftlead_fix
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
huki_ruddershaftlead_fix [2024/03/27 19:49] preavley removed |
huki_ruddershaftlead_fix [2025/03/23 19:49] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | |====== Repairing leaks in thru-hull rudder shaft (tube) ====== | + | ====== Repairing leaks in thru-hull rudder shaft (tube) ====== |
| - | \\ (always wear protactive goggles and gloves.) \\ | + | |
| + | always wear protective goggles and gloves. | ||
| - Make sure the inside of the canoe is completely dry. Remove the rudder. If you have determined that the leak is near the bottom of the rudder shaft, the canoe will be supported right side up. If you have determined that the leak is located at the top of the rudder shaft, the canoe will be supported upside down. | - Make sure the inside of the canoe is completely dry. Remove the rudder. If you have determined that the leak is near the bottom of the rudder shaft, the canoe will be supported right side up. If you have determined that the leak is located at the top of the rudder shaft, the canoe will be supported upside down. | ||
| - Fill a plastic composites syringe with an ounce of catalyzed epoxy. Place your thumb over the bottom end of the rudder shaft so as not to allow any resin to drip out of the shaft. Place the syringe over the top of the shaft and pump the resin into the shaft hole. | - Fill a plastic composites syringe with an ounce of catalyzed epoxy. Place your thumb over the bottom end of the rudder shaft so as not to allow any resin to drip out of the shaft. Place the syringe over the top of the shaft and pump the resin into the shaft hole. | ||
| Line 7: | Line 9: | ||
| - Redrill the hole to size with a 5/16 inch drill bit. | - Redrill the hole to size with a 5/16 inch drill bit. | ||
| - Retest for leaks. If leaks, repeat the repair. Note: if the inside of the canoe was not completely dry, nothing you attempt for repair will work. | - Retest for leaks. If leaks, repeat the repair. Note: if the inside of the canoe was not completely dry, nothing you attempt for repair will work. | ||
| - | | | + | |
| + | from [[https://www.huki.com/index.php?page=Repairing_Rudder_Leaks|Huki website page]] - Jude Turczynski | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
